Mobile pool service across Corona, CAMon–Fri 7am–5pm · Sat 8am–2pm
Questions? Reach us at 951-545-4118📞 Call💬 Text

Home › Services › Pool Equipment Repair › Pool Heater Repair

Pool Heater Repair in Corona, CA

Heater won't light, keeps shutting off or barely warms the water? We come to you, find the cause and fix it, or show you the replacement options.

Corona Swimming Pool Service repairs pool and spa heaters at homes in Corona, CA. The most common reasons a pool heater stops working are low water flow from a dirty filter or a slow pump, a tripped pressure or high-limit switch, an ignition or sensor fault, and scale inside the heat exchanger. Heater repair is part of our pool and equipment repair in Corona, and we quote before any work starts.

Pool Heater Not Working? Check These First

  1. Is the pump running and the filter clean? Most heaters won't fire without enough water flow. A clogged filter or full baskets are the number one cause.
  2. Is the heater set to "pool" or "spa" and the temperature set above the water temperature? Check the controller and any automation schedule.
  3. Is there power, and is the gas valve open? Check the breaker, and for gas heaters make sure the gas supply is on.
  4. Is there an error code on the display? Write it down. It tells a technician where to start.

If those all look right, turn the heater off and call us. Don't keep resetting a heater that shuts itself off.

Common Heater Problems We Fix

  • Won't ignite or clicks without lighting: ignition, flame sensor or gas valve problems
  • Turns on, then shuts off: low flow, a pressure switch, a high-limit switch or a thermostat fault
  • Heats slowly: scale in the heat exchanger, an undersized heater or air flow problems on a heat pump
  • Leaking or rusting: a failing heat exchanger or fittings, often from water that has been out of balance
  • Error codes: we read the code, test the part and replace only what has failed

Why Water Balance Matters for Heaters

Corona's hard water leaves calcium scale inside heat exchangers, and low pH water corrodes them. Both shorten a heater's life. Keeping the water balanced on weekly pool cleaning is the cheapest way to protect a heater.

Repair or Replace?

A heater with one failed part is usually worth repairing. A heater with a leaking heat exchanger or several problems at once is often better replaced. We show you both options and the cost of each before you decide.

How It Works

  1. Call or send a message. Tell us about your pool and what it needs.
  2. Get a clear quote. We look at your pool and equipment and give you a price before any work starts.
  3. Relax. We come to your home on a set day and keep your pool clean and balanced.
Freshly cleaned freeform pool and spa with a suction cleaner running
Clear blue hillside pool and spa after a service visit

Serving Homes Across Corona

We're a mobile pool service, so there's no shop to visit. We come to you. We look after pools across Corona ZIP codes 92880, 92881, 92882 and 92883. Not sure if we cover your street? Give us a call.

See our service area

Common Questions

Why is my pool heater not turning on?

Usually low water flow from a dirty filter or a pump that isn't running, a heater set below the water temperature, or a tripped switch. If those check out, it is often an ignition or sensor fault that needs a technician.

Why does my pool heater turn on and then shut off?

Short cycling is most often caused by low flow, a faulty pressure or high-limit switch, or a thermostat problem. Clean the filter first; if it continues, turn the heater off and call for service.

How long should a pool heater last?

Many pool heaters last around 7 to 12 years, depending on the type, how often it runs and how well the water is balanced.

Do you repair spa heaters too?

Yes. Most pool and spa combinations share one heater, and we repair it for both.

Ready for a Cleaner Pool?

Spend your weekends in the pool, not cleaning it.